Monday, 3 August 2020

Locker Flanges | Rounding Over

When the flanges for the locker openings in the seatbacks were fully cured I rounded them over on the inside edge with a 1/4" bit in the router.

Here is the starboard seatback on the bench, held up from the bench with pieces of ply to give clearance for the router bit. More pieces of ply of the same thickness as the flanges are laid on top of the seatback to provide a wide surface for the router to slide across.



It took a while to set up but the task was completed in minutes.

3 comments:

  1. This comment has been removed by a blog administrator.

    ReplyDelete
  2. This comment has been removed by a blog administrator.

    ReplyDelete
  3. This comment has been removed by a blog administrator.

    ReplyDelete