Upper Hull | Third Coat of Gloss

I left the second coat to harden for a few days before sanding it smooth. This time I used a P280 grit, having found the P320 was making hard work of it.

This is the forward deck well.

And this is the cockpit.

The paint was nice and hard and sanded well - no bare patches this time!

I was now using abrasive nylon finishing pads to sand the fillets and rounded edges. This is them.

The red medium grade is ideal for abrading the gloss - not too aggressive and not too fine.

Then the third coat went on. This time I reduced the amount of thinners to 5% to see if it made much difference to the flow out. It didn't seem to.

This is the port quarter after gloss.

This is the starboard cabin top.

That's not too bad!

I'm still having the occasional problem with losing the wet edge, and I have not covered the rounded edges too well in places, but I'm pretty sure that's because I didn't use enough paint and 'starved' the surface.

The finish gets better as the task progresses and the roller sleeve gets fully loaded up with paint. I think with more care and better lighting I could get it right.

I will now leave everything to harden off before more sanding. I'm going to switch to Epifanes Easy Flow to thin the paint to see if that improves flow and finish.

We are getting there!