The boat will need to be supported when upside down in the garage, so a pair of dollies is required.
I didn't need to think too hard about how to do this, having already done it once.
I used the same measurements and used the mitre saw to cut some inexpensive but strong studding to length. Like this.
It didn't take too long to make them, and I fitted some braked casters so the boat can be easily moved around.
Here they are.
As before a stout vertical timber post takes the compression load at the stern on each side, and a strong plastic bucket is fixed over it to keep it upright.
Onwards and upwards.
No comments:
Post a Comment