As stated in the previous post, I decided to go with the aluminium bracket because I thought it would be more robust and easier to use in practice.
It did, however, require a fair amount of rework to make it fit for purpose.
The first issue was the wooden mounting pad. It wasn't tall enough to accommodate a standard outboard bracket - it was a good 30mm too short.
It was also made of cheap and nasty construction ply, with a quick splash of stain to make it look respectable.
So that had to be replaced.
I removed the pad. Here it is, with its fastenings.
The fastenings turned out to be coach bolts with spiked washers, and obviously not stainless steel. They would be suitable for building a garden shed, but nothing to do with boats.
Here it is being glued up.
That went well so I cut out the pad to size and cleaned it up, like this.
I used the old mounting pad to mark up the location of the fastenings on the new blank.
In this pic I am drilling the countersink for the spring which fits behind the pad and bears against the connecting arm, to help the arm stay in place.
A Forstner bit is ideal for this purpose. Next came a test fit for the spring, like this.
Perfect!
Next I drilled the countersink holes for the bolts, again using a Forstner bit. This is what they looked like.
Finally, I drilled the holes for the M8 bolts, like this.
So far, so good. And I was feeling pretty pleased with my progress... until I tried a test fit onto the bracket.
It didn't fit. The bolt holes did not align. Aghast, I assumed that I had made a silly measuring error.
But when I checked my mistake by aligning the original pad with the bracket, this is what it looked like.
As you can see, the original pad never did fit! The flanges on the bracket must have been twisted out of shape before the coach bolts were hammered through. What a piece of crap!
I think this bracket must have been made - or at least finished - in some weird place that still uses Imperial measures and has no regard for quality manufacture. Any ideas?
So, back to square one for the wooden pad...
Luckily I had plenty of 9mm marine ply still to hand, so I made a new blank. Here it is being glued to make an 18mm pad.
Next I made a template for drilling the bolt holes, to be certain that it didn't go awry a second time.
I decided to round over the edges and corners, using the router table. Here is the table, set up for action.
I'm not sure if I mentioned this yet, but I decided to fit a 'buffer pad' between the outboard bracket and the transom. This is mainly to prevent the metal bracket from gouging lumps out of the lovely Sapele veneer on the transom itself, so the buffer pad is really sacrificial.
Both pads then received four or five coats of clear resin to seal them, sanded with a P80 grit between coats. Here they are.
While the resin was curing I did some fettling on the aluminium cantilever assembly of the bracket. It was quite well made but needed some finishing to make it fit for purpose.
I would have preferred to use Epifanes but I have run out, and it is not worth buying a whole litre tin for such a small job.
They are looking quite nice. I mustn't spend too much effort making them pretty, because the motor pad will quickly become gouged and marked by the engine mount...
No comments:
Post a Comment